Traditionally, table saws tilted their blades to the right, in the direction of the rip fence, as was viewed most practical for right-handed users. A few long-standing models, including the Powermatic model 66, tilt Dewalt Table Saw the left, which helps prevent stock from binding and kicking back during bevel cuts. Taking miter cuts with the blade tilted left is also advantageous, as marked cut lines are on top where you can see them. While many woodworkers still prefer a right-tilt saw, left-tilting saws are popular enough that many makes/models of cabinet, contractor and portable saws are now available as southpaws. Making the Cut. When cutting small or narrow workpieces, use a push stick to feed the stock forward and a featherboard to help it bear against the rip fence. Regardless of the kind of cut you're making, make sure that the stock— and your hand and fingers— are clear of the blade before hitting the saw's “On” switch. When taking a rip cut, make sure that one edge of the stock has Best Impact Wrench or jointed so that it's arrow straight. Set that edge against the rip fence, start the saw, then use a push stick to feed the work into the spinning blade. Feed at an even rate of speed while keeping the work in firm contact with the fence. If your stock is narrow, it's best to use a featherboard to keep the work pressed against the fence and down on the saw table. Whenever possible, stand to the side of the stock and blade rather than directly behind it. That way, if the workpiece is kicked back, it won't strike you. When ripping dense hardwoods or “problem” boards (wood with knots, twisting grain, etc), the motor/blade may bog down as you cut. In this case, try easing off on your feed speed. If the work starts smoking or binds on the blade, it's best to turn the saw off immediately, remove the board, then repeat the cut or switch to a different piece of lumber. Small- and medium-sized pieces of plywood and other sheet goods are easy to cut, even on compact jobsite table saws, using the saw's standard rip fence. Large panels and sheet goods can also be ripped using the rip fence as a guide. If you cut a really big piece, make sure it's well supported at both ends of the cut with infeed and outfeed tables or supports. You can also crosscut large panels as long as the work isn't too long or the side that rides against the fence isn't too narrow. When using the miter gauge, make sure that the end of long workpieces won't hang up on the rip fence before you begin. Unless your stock is hard Best Hammer Drills , you can use hand pressure to keep the work firmly planted against the face of the gauge (a piece of peel-and-stick sandpaper applied to the face helps keep the work steady during cutting). When you're ready, slide the miter gauge and work slowly and evenly through the cut, making sure to keep both hands well clear of the blade. After the cut is complete, it's safest to shut the saw off before removing the workpiece and cutoff scrap: never reach over a spinning saw blade! For long, large, or extra short Types Of Chainsaw Chains, either clamp the work to the gauge's head or use a table saw crosscutting sled or specialized jig.